Reference [Projects]

H

INT

It is also possible to erase the currently loaded project. In this 

PRJ PRT

PRJ PRT

case, the lowest numbered project will automatically be 

OFF

OFF

loaded after the erase operation has been completed. 

2.

Turn the dial to select ON (write protect enabled) 

Editing the project name 

or OFF (write protect disabled). 

When write protect is ON for a project, a lock symbol 

 is 

This lets you edit the name of the currently loaded project. 

shown to the right of the project number. 

1.

Refer to steps 1   2 of  Basic procedure  to bring 

up the indication  PROJECT NAME  on the display. 

PRJ 008

PRJ 008

Then press the [ENTER] key. 

PRJ008

PRJ008

The current project name is shown on the display. 

Lock symbol

A change in the protect status becomes active immediately. 

PRJ NAME

PRJ NAME

To return to the main screen, press the [EXIT] key several 

PRJ010

PRJ010

times. 

2.

To edit the name, use the cursor left/right keys to 

N

OTE

move the flashing position to the character you 

If a project is loaded for which write protect is not enabled, 

want to change, and turn the dial to select a 

and you select another project, the current project's mix 

character. 

settings will be overwritten, because the existing project is 

automatically saved on the hard disk before loading the new 

For information on available characters, refer to page 34. 

project. If you do not want a completed mix to be changed 

To return to the main screen after editing the name, press the 

further, it is recommended to set write protect to ON. 

[EXIT] key. 

H

INT

The various track parameters such as EQ and panning can 

Protecting/unprotecting a project 

be adjusted also when the project is protected (but the 

settings will not be stored). 

This operation lets you write protect the currently loaded 

project or turn previously enabled protection off. When 

protect is ON, the following operations will be impossible. 

  Deleting a project 

  Editing or recording on the recorder 

  Changing the V take 

  Editing a patch (including module on/off) 

  Recording or editing a rhythm pattern or rhythm song 

  Saving scenes, making marker settings, etc. 

1.

Refer to steps 1   2 of  Basic procedure  to bring 

up the indication  PROJECT PROTECT  on the 

display. Then press the [ENTER] key. 

The screen for setting the protect status to ON/OFF is shown 

on the display. 

ZOOM MRS 802

127