Reference [Mixer]

H

INT

To cancel a scene assignment, turn the dial to make the 

Permissn

Permissn

display indicate       . 

AllFader

AllFader

 ON

6.

Locate the next mark at which you want the mix to 

change, and repeat steps 4   5. 

2.

Turn the dial to set fader permission to ON or OFF. 

7.

When scenes have been assigned to all marks, 

3.

Press the other keys for parameter groups, to 

press the ZERO [U] key to return to the beginning 

enable or disable the group. 

of the song, and then press the PLAY [R] key to 

Except for the fader, scene control for the other groups can 

start playback. 

be enabled or disabled by pressing one of the keys listed 

Each time the song reaches a mark to which a scene has been 

below. 

assigned, that scene will be recalled. 

  TRACK PARAMETER group 

Any status key except [MASTER] status key 

Deleting certain parameters from a 

  INSERT EFFECT group 

scene 

Any [INSERT EFFECT] key 

  CHORUS/DELAY group 

If desired, you can disable a group of parameters saved in a 

[CHORUS/DELAY] key 

scene. Such parameters will not change even if that scene is 

  REVERB group 

recalled. The following groups of parameters can be 

[REVERB] key 

specified and made active or inactive. 

When a group is enabled, the respective keys are lit, and 

Group 

Item 

when the group is disabled, the keys are flashing. 

EQ HI 

EQ LO 

TRACK 

H

INT

Chorus send 

PARAMETER

  The TRACK PARAMETER group can be enabled or 

Reverb send 

disabled for each audio track and the drum track 

Pan 

separately. 

Play/mute 

Patch number 

  You can also use the cursor up/down keys to enable or 

INSERT EFFECT

Input source 

disable all groups together. 

CHORUS/DELAY Patch number 

REVERB

Patch number 

4.

When the setting is complete, press the [EXIT] key. 

ALL FADER

Fader position 

The unit returns to the scene menu. 

For example, after you have programmed a sequence of 

5.

To return to the main screen, press the [EXIT] key. 

automatic scene changes, you may want to disable the 

The parameter group on/off status is stored as part of the 

TRACK PARAMETER group and set only the EQ and 

project. 

panning parameters manually for each track. 

1.

Press the [SCENE] key in the control section, and 

then press the [UTILITY] key in the display section. 

The following screen appears on the display. In this 

condition, you can enable or disable the faders for each 

scene. 

ZOOM MRS 802

76