Reference [Mixer]

Adjusts the amount of high range boost/cut. 

Range: 

 12   0   12 (dB) 

Adjusting depth of send/return effect 

Default:

 0 

This section explains how to adjust the effect depth by 

setting the volume that is sent from each channel to the send/

  EQ HI F parameter 

return effects (chorus/delay, reverb). Raising the send level 

will produce a deeper effect. 

TR1

TR1

EQ HI F

EQ HI F

 8000

1.

Press the [CHORUS/DELAY] key or [REVERB] key 

to select a patch for the send/return effect. 

Adjusts the turnover frequency for high range boost/cut. 

The display changes and shows the currently selected patch 

Range: 

500   18000 (Hz) 

of the selected effect (chorus/delay or reverb). 

Default:

 8000 

2.

Turn the dial to select the patch you want to use. 

  EQ LO G parameter 

You can also select a patch by using the PATCH SELECT 

[

Q

]/[

W

] keys in the effect section. 

When you have selected the patch, press the [EXIT] key. 

TR1

TR1

EQ LO G

EQ LO G

    0

3.

Press the [TRACK PARAMETER] key in the track 

Adjusts the amount of low range boost/cut. 

parameter section and use the cursor up/down 

Range: 

 12   0   12 (dB) 

keys to bring the following indication onto the 

Default: 

0 

display. 

  EQ LO F parameter 

  Adjusting the chorus/delay send level 

TR1

TR1

EQ LO F  

EQ LO F  

TR1

TR1

  125

CHO SEND

CHO SEND

    0

Adjusts the turnover frequency for low range boost/cut. 

Range: 

40   1600 (Hz) 

  Adjusting the reverb send level 

Default: 

125 

TR1

TR1

H

INT

REV SEND 

REV SEND 

    0

  If you press the [ENTER] key while the EQ HIGH parameter 

is displayed, EQ HIGH is turned off. Pressing the key once 

more turns EQ HIGH on again. In the same way, you can 

4.

Press the status key for the audio track or the  

switch EQ LOW between on and off with the [ENTER] key 

drum track to which you want to apply the effect. 

while the EQ LOW parameter is displayed. 

  Immediately after switching the display, the audio track or 

5.

Turn the dial to select the effect depth. 

the drum track that was selected before will still be 

Higher values result in more effect depth (stronger effect). 

selected. If necessary, switch to another track. 

The range and default values for the parameters are shown 

5.

Set the EQ parameter for other audio tracks or the 

below. 

drum track in the same way. 

  CHORUS/DELAY SEND: 0   100 (default: 0) 

6.

When you have finished adjusting settings, press 

  REVERB SEND: 0   100 (default: 0) 

the [EXIT] key. 

The unit returns to the main screen. 

ZOOM MRS 802

72