Reference [Track Editing]

The subsequent steps will differ, depending on which 

The point can be specified in hours/minutes/seconds/

command was selected. See the sections for the respective 

milliseconds. When a value is specified, the measure/beat/

commands. 

tick counter reflects the new location. 

If you move the flashing section to the MARKER field on 

7.

When the editing command has been executed, 

the display, you can specify a mark by turning the dial. In 

repeatedly press the [EXIT] key to return to the 

this case, the mark position becomes the editing start point. 

main screen. 

If you move to an area where no data are recorded, a  *  

symbol is shown. 

H

INT

3.

Press the [ENTER] key. 

After performing an edit function and rewriting the audio data 

on a track, the original data cannot be restored. If you want 

The display changes to  Copy Src END . This screen lets 

to retain the condition before editing, use the capture 

you specify the copy range end point. 

function for that track (

 p. 55). 

Copy Src

Copy Src

02

Copying a specified range of data 

END

END

0 213  0 058  3  8

You can copy the audio data of a specified range to a 

specified position on a specified track. This action will 

4.

Use the same procedure as in step 2 to specify the 

overwrite the existing data at the destination location. The 

copy range end point. 

copy source data will be unchanged. 

If you press the PLAY [

R

] key at this point, the specified 

range will be played. 

Copy source track

5.

Press the [ENTER] key. 

Copy

The display now shows  Copy Dst TR xx yy  (where xx is 

the track number and yy the V take number). This screen lets 

you specify the copy destination track/V take. 

Copy destination track 

1.

Copy Dst

Copy Dst

Refer to steps 1   6 of  Basic editing steps  to 

TR 1  1

TR 1  1

select the copy source track/V take, and press the 

[ENTER] key. 

The display changes as follows. This screen lets you specify 

N

OTE

  If you have selected a single track as copy source, only a 

the copy range start point. 

single track can be selected as copy destination. 

  If you have selected two adjacent tracks or the master 

track as copy source, only two adjacent tracks or the 

Copy Src

Copy Src

00

master track can be selected as copy destination. In this 

START 

START 

case, the currently selected V take for each track becomes 

0 0 0  0 001  1  0

the editing target. 

The edit range start point is shown on the left hand counter 

6.

Specify the copy destination track/V take in the 

in hours, minutes, seconds, milliseconds, and on the right 

same way as when selecting the copy source 

hand counter in measures, beats, and ticks. 

track/V take, and press the [ENTER] key. 

The display changes as follows. This screen lets you specify 

2.

Use the cursor left/right keys to move the flashing 

the start point on the copy destination V take. 

section of the counter, and turn the dial to specify 

the copy start point. 

ZOOM MRS 802

47